Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Fort Lauderdale Owner’s Guide

Ghost Controls keypad and intercom repair in Fort Lauderdale typically runs $165 – $285 installed, and we stock the most common Ghost Controls-compatible keypads, intercom modules, and wiring harnesses on our trucks for same-day replacement in most cases. The usual story we hear: the keypad works intermittently, then only when you press hard, then not at all. Or the intercom crackles, drops calls, or the gate won’t open from the house unit but the remote still works fine.

Call (754) 354-2542

If you’re standing at your gate right now pressing buttons and getting nothing, here’s what matters: Ghost Controls keypads and intercoms fail for predictable reasons in South Florida weather, and most of those failures are repairable or replaceable in under an hour. We’re an independent service provider, not affiliated with Ghost Controls, but we’ve worked on their systems long enough to know exactly which parts fail first and which replacement parts actually hold up in Fort Lauderdale’s heat and salt air.

Key Takeaways:

• Installed keypad or intercom repair: $165 – $285 before we touch anything, in writing
• Most Ghost Controls keypad and intercom jobs are done the same day we answer your call
• We carry OEM Ghost Controls parts plus quality aftermarket equivalents for older models where OEM is discontinued
• Every repair gets our 365-Day Done Right Promise: if it fails within a year, we come back free

Which Ghost Controls Models This Applies To

Ghost Controls makes a few keypad and intercom lines that get confused constantly, and getting the wrong one means a return trip. The wired keypad (AXWK) works with the TSS1 and TDS2 series control boards. The wireless keypad (AXWR) pairs with the same boards but needs the antenna module on the control box. The intercom setup is a different animal: Ghost Controls uses a two-wire or Cat5 intercom module that connects to the visitor keypad at the gate talk-back station, and it’s compatible with the DTP1 and DTP2 series gate opener control boxes.

How to identify what you have: open the battery compartment or the back plate and look for the model sticker. If the sticker is gone from sun and rain, measure the keypad face. Ghost Controls keypads are 5.5 inches tall by 3 inches wide, which is smaller than most DoorKing and LiftMaster keypads. That matters because a universal aftermarket keypad rarely fits the existing Ghost Controls mounting plate or the cutout in your gate post.

On the OEM versus aftermarket question for Ghost Controls specifically: we’ve had better luck with genuine Ghost Controls keypads for the wireless models because the pairing protocol is picky. For wired keypads and intercom modules, a quality aftermarket equivalent from a brands like Linear or LiftMaster often works fine and costs less. We’ll give you both options with prices and let you decide.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

Here’s what we see most often on Ghost Controls keypad and intercom units in Fort Lauderdale. If any of these sound familiar, the part is usually on its last legs:

• Keypad works only when you press one corner hard. The membrane switch contacts inside are corroded. This is the number one Ghost Controls keypad failure in coastal Fort Lauderdale, where salt air gets past the seal and eats the contact traces.
• The keypad lights up but the gate doesn’t move. The keypad itself may be fine. Often this is a broken data wire between the keypad and the control board, especially after heavy rain or if the wire run goes through a flower bed. We test the keypad before we replace anything.
• Intercom buzzes constantly or picks up radio stations. The intercom module’s internal capacitor has failed or the wiring has a partial short. We see this a lot on Ghost Controls intercoms older than five years. The fix is usually a new intercom module, not a new keypad.
• The gate opens from the keypad but the visitor’s voice never comes through the intercom. The intercom module is dead or the speaker in the keypad face is blown. Salt water from nearby canals accelerates this on properties along the Intracoastal.
• Someone pressed the keypad a hundred times and now the code doesn’t work. Ghost Controls keypads have a lockout after too many wrong entries. Sometimes the keypad is actually fine and just locked. We can reset it in five minutes. If it unlocks and still won’t take the code, the keypad’s memory chip is done.

Replacement Cost & What’s Included

For Fort Lauderdale, a Ghost Controls keypad or intercom replacement lands between $165 and $285 installed. The lower end is a wired keypad swap on a gate with easy access. The upper end is a wireless keypad plus pairing, or an intercom module replacement with a new speaker wire pulled. Here’s the breakdown:

• Keypad only (wired): $165 – $215 installed, part typically $85 – $120
• Keypad only (wireless): $195 – $255 installed, includes pairing and antenna check
• Intercom module: $215 – $285 installed, part typically $110 – $170
• Both keypad and intercom together: $350 – $450 installed, we discount the labor when done in one visit

Those prices include the part, the labor, the wiring check, and programming your entry codes back in. You get the written price before we touch a single bolt, and that’s the number you pay. No surprise add-ons at the end. Every job also includes our 365-Day Done Right Promise: if the keypad or intercom fails within a year, we return and fix it at no charge.

DIY or Call Us?

Keypads and intercoms are low-voltage, so the electrical danger here isn’t what you’d face with a gate opener motor or a tension spring. But these parts live outside, and the failure modes are often in the wiring rather than the part itself. A homeowner can safely check a few things: make sure the keypad isn’t in lockout from too many wrong codes, check the batteries (if wireless), and confirm the gate still opens from a remote or wall button. That tells you whether the problem is the keypad or the gate opener itself.

Where DIY goes wrong: Ghost Controls wireless keypads need a specific pairing sequence that’s easy to get wrong and frustrating the third time you try it. Wired keypads often fail because of a broken wire inside a conduit, not a bad keypad, and you can’t diagnose that without a meter. And if your intercom stopped working after a storm, there may be a direct lightning hit to the wire run that an ohm meter will find, but visual inspection won’t. We fix this stuff in under an hour. Call us at (754) 354-2542 and we’ll get someone on it.

Nico Alvarez has spent years on Fort Lauderdale gate systems, and he will tell you the same thing he tells every customer: “Tell me what it’s doing wrong, I’ll tell you what it costs to fix it, in writing, before we start.”

FAQs