Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateTrusted Electric Gate Repair for Fort Lauderdale Homeowners
Electric Gate Repair - Fort Lauderdale typically costs $185 to $420 for most opener and sensor jobs, and our team can usually be at your driveway within hours, not days. A gate that won’t open, grinds when it moves, or stops halfway isn’t just an inconvenience. It blocks your car, leaves your property exposed, and usually gets worse the longer it runs misaligned. Calder Gate Repair Fort Lauderdale has handled these problems since 2009 as part of the Relay Home Co. family, with every job covered by the 365-Day Done Right Promise and a written price before any work starts. Call (754) 354-2542 and a live person answers, 24/7.
Key Takeaways:
- Most electric gate repairs in Fort Lauderdale run $185 to $420 before parts.
- Same-day and emergency service is available for repair calls across the Fort Lauderdale area.
- Every job includes a written price before work starts and a 365-day written guarantee.
- We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule openers.
Automatic Gate Repair
Automatic Gate Repair is what we do when the gate stops responding the way it should: the remote won’t trigger it, the gate reverses before it closes, or the motor runs but the gate barely moves. In Fort Lauderdale’s salt air and afternoon downpours, circuit boards corrode, limit switches fail, and ground loops get wet, so these issues show up more here than in drier parts of the country. Calder Gate Repair Fort Lauderdale diagnoses the exact point of failure, replaces only what’s broken, and leaves you with a written record of what was done and why. Most automatic gate repairs run $185 to $420 before parts, and the price is agreed in writing before we turn a screw.
Remote and Receiver Failures
The gate stopped responding to the remote, or it only works when you’re inches from the receiver with the clicker held against the windshield. We test the remote’s signal strength, check the receiver antenna, and replace or reprogram whatever failed. Sometimes it’s a dead battery and sometimes it’s a fried receiver board, and we figure out which before quoting a dollar number.
Limit Switch Calibration
The gate slams at the end of its travel, or reverses before it ever reaches the post, or stops three feet short. That’s the limit switch, the small sensor that tells the gate when to stop at the open and closed position. We recalibrate or replace it, then run the gate through full cycles in both directions to confirm it stops exactly where it should.
Styles & brands we work with
Electric Gate Motor
Electric Gate Motor repair is the fix when the opener’s motor runs but the gate doesn’t move, or the motor hums and shuts off, or it trips its internal breaker after every cycle. The motor is the muscle of the whole system, and on sliders in Fort Lauderdale it works against sand and salt every single day. Calder Gate Repair Fort Lauderdale diagnoses whether the problem is the motor itself, the capacitor, the gearbox, or the drive chain, and quotes the repair in writing before starting. Motor repairs generally land between $225 and $475 before parts, depending on the motor type and how much of the drive assembly needs attention.
Capacitor and Gearbox Issues
The motor clicks or hums instead of starting, which is almost always the start capacitor or a stripped gear inside the gearbox. We test the capacitor under load, inspect the gears for worn teeth, and replace the failed component rather than selling you a whole new opener. Most of the time the motor itself is still healthy and the repair is quick and affordable.
Drive Chain and Belt Alignment
The gate jumps, jerks, or makes a grinding sound as it travels, and the motor is working harder than it should. That’s usually a loose or worn drive chain or belt, and running it that way accelerates wear on the motor. We tension or replace the chain or belt and align the sprockets so the gate moves smoothly and quietly again.
Gate Access Control
Gate Access Control is the system that decides who gets through: keypads, intercoms, telephone entry units, vehicle loop detectors, and the control boards that run them. When it fails, you’re either locked out of your own driveway or the gate stays open for anyone who drives up. Calder Gate Repair Fort Lauderdale repairs and replaces entry hardware, re-terminates corroded wiring, and programs boards so the whole system talks to itself again. Access control repairs start around $160 and can reach $600+ when the control board or entry panel needs replacement, with the exact number always on paper before we start.
Keypad and Intercom Repair
The keypad won’t accept the code, or the intercom buzzes but you can’t hear the visitor, or the entry panel is fogged and cracked from the Florida sun. We replace keypads, repair or swap intercom handsets, and program new codes on the spot. If the issue is in the buried wiring between the house and the gate, we locate and repair that too.
Loop Detector Replacement
The gate opens for cars leaving but won’t recognize your car arriving, or it closes on a car that’s still passing through. That’s the loop detector, the buried wire that senses the metal of a vehicle, and Fort Lauderdale’s wet sandy soil is rough on those loops. We test the detector, check the loop’s resistance, and install new loops or a new detector as needed.
Commercial Gate Operator
Commercial Gate Operator service is what keeps an apartment complex, warehouse, marina, or church parking lot gate running hour after hour without failure, and our Electric Gate Repair in Pompano Beach covers the same commercial-grade systems. A commercial operator cycles hundreds of times a week, not dozens, so wear items like bearings, chains, and capacitors fail faster and downtime affects more than just one household. Calder Gate Repair Fort Lauderdale repairs commercial operators on site, keeps common parts on the truck, and schedules the work to minimize how long the gate is out of service. Commercial gate operator repairs typically run $320 to $850 before parts, quoted in writing and scheduled around your traffic patterns.
High-Cycle Wear Components
Commercial gates fail most often at the components that move the most: chains stretch, bearings wear out, and capacitors blow. We inspect the full drive assembly, identify every component near the end of its service life, and replace what’s worn before it shuts the gate down entirely. The goal is a single repair visit that holds up for years of daily cycles.
Safety Edge and Photo Eye Restoration
A commercial gate that won’t close, or that reverses for no reason, usually has a failed safety edge or a misaligned photo eye. These are the non-negotiable safety devices that prevent the gate from closing on a car or a person, and we treat them as critical. We test every safety input, repair or replace what’s failed, and confirm the gate stops and reverses exactly as it should before we leave.
Brands We Service
We keep Ghost Controls hardware in stock because it’s the most common brand we see on newer Fort Lauderdale residential gates, especially the sliding and swing gate kits sold to homeowners. Our techs know the Ghost Controls programming sequence, the common control board failure points, and which parts interchange between models, which means we can usually have that gate working again on the first visit.
DoorKing and Elite are the workhorses of South Florida commercial and condo gates, and we’ve serviced both brands across Broward County for years. Mighty Mule shows up on residential double swing gates everywhere, and we know exactly which generation of control board yours has and what it costs to replace. Whether you have Ghost Controls, DoorKing, Elite, Mighty Mule, or any other make, we can help.
Signs You Need a Pro Right Now
- The gate reverses before it closes. This means a safety edge, photo eye, or limit switch is sending a false “obstruction” signal, and your gate will keep refusing to close until it’s fixed. It’s also a security problem: a gate that won’t close is an open invitation to anyone driving by.
- The motor hums but nothing moves. The motor is getting power but the drive can’t transfer it, usually due to a failed capacitor, stripped gear, or broken sprocket. Running it in that state for days or weeks can burn out the motor entirely and triple the repair cost.
- The remote only works from a few feet away. A weak signal means a failing receiver, a damaged antenna, or interference, and it will get worse until the remote stops working altogether. It’s usually a quick, low-cost fix now and a more expensive board replacement if ignored.
- The gate grinds, jerks, or squeals as it moves. Noise is friction, and friction is wear. A gate that grinds is telling you the chain, rollers, or bearings are failing, and every cycle makes the repair more involved. Catch it early and it’s a lubrication and adjustment call instead of a parts replacement.
- The keypad or intercom stopped responding. Access control failures lock you out or leave the property open, and they rarely fix themselves. The problem is usually in the keypad, the wiring, or the control board, and a pro can identify which in a single visit instead of you replacing parts by guesswork.
See the difference
Before
After
Before
After
Before
AfterOur Process, Step by Step
- 1
You call or book online, and a live person answers. No phone tree, no voicemail, no “we’ll get back to you.” Tell us what the gate is doing, and we’ll give you an arrival window you can track on your phone, rideshare style.
- 2
We arrive, diagnose, and photograph everything. The tech checks power, tests the motor and safety devices, and identifies the exact failed component before touching anything. We show you what’s broken and explain it in plain words, not gate jargon.
- 3
You approve a written price before any work starts. The number on that quote is the number on your invoice. Not an estimate that triples at the door, not a “we found more problems” surprise. If we find additional issues mid-repair, you get a new number and you approve it before we proceed.
- 4
We complete the repair and cycle-test the gate repeatedly. Full open and close cycles, safety reversal tests, remote range checks, and a final inspection of every component we touched. We don’t leave until the gate operates correctly under real conditions.
- 5
You get a digital invoice and your 365-Day Done Right Promise in writing. Pay from a link, keep the paperwork on your phone, and rest easy knowing that if this repair fails within 365 days, Calder returns at no charge. That’s the Relay Standard: live arrival time, before-and-after photos, digital invoice, real guarantee.
How Much Does Electric Gate Repair Cost in Fort Lauderdale?
A typical Electric Gate Repair in Margate or Fort Lauderdale runs $185 to $420 before parts, with most jobs landing right around $275. Simple fixes like remote programming, limit switch recalibration, or keypad replacement sit at the low end of that range. Motor capacitors, gearbox repairs, or loop detector replacements push toward the top. Commercial operator repairs run $320 to $850 before parts, and full control board replacements on older systems can exceed that. Fort Lauderdale’s salt air and sandy soil mean we see more corrosion-related failures than inland technicians deal with, which is exactly why we price them honestly instead of bundling everything into a mystery “service fee.”
- What affects the price: the brand and age of the opener, whether it’s a slider or swing gate, how accessible the motor and control board are, and which specific component failed.
- How to avoid overpaying: get the diagnosis before you get the quote, question any tech who wants to replace the whole opener for a single failed part, and check whether the repair includes a written guarantee. Ours always does, for 365 days.
- What a free estimate includes: the diagnostic visit, a written line-item price for the repair, and a clear explanation of what failed and why. You approve the number before we start, and if the job requires additional parts, you approve the updated number before we proceed.
Our Service Area Near Fort Lauderdale
We run repair calls throughout Broward County, so if you’re in Pompano Beach, Sunrise, Margate, Hallandale Beach, Cooper City, West Park, Lighthouse Point, Wilton Manors, Oakland Park, Broadview Park, or Dania Beach, we can reach you quickly. Most Fort Lauderdale calls get same-day service, and our home base in the city keeps travel time down. Electric Gate Repair in Fort Lauderdale is our specialty, and nearby communities get the same 24/7 live answer and written pricing.
Serving Fort Lauderdale, FL - Our Local Coverage Area
We’re based in the Fort Lauderdale area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions About Electric Gate Repair in Fort Lauderdale
Electric gate repair is the diagnosis and correction of any failure in the motor, control board, safety sensors, remote receiver, keypad, or drive mechanism that prevents an automatic gate from opening and closing properly. It can range from reprogramming a remote to replacing a burned-out motor. A trained tech identifies the exact failed component and repairs it rather than guessing. We cover all of it, including commercial operators.
Most residential repairs are completed in one visit of 60 to 90 minutes. Jobs that require replacing a control board or motor might take two hours if the parts are on the truck, longer if we need to order a specific board. We’ll give you an honest time estimate before the work starts. Same-day scheduling is available for most Fort Lauderdale calls.
Residential electric gate repairs in Fort Lauderdale typically run $185 to $420 before parts, with most jobs around $275. Commercial repairs run $320 to $850 before parts. The exact price depends on the failed component, the brand, and the gate type. You’ll get a written price before any work starts, and that’s the number you pay. Call (754) 354-2542 for a free estimate.
Yes, we service LiftMaster openers daily across Fort Lauderdale, including swing and slide models, and we keep common LiftMaster parts on our trucks. We also repair FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, along with most other brands found in Broward County. If you know your brand, tell us when you call and we’ll come prepared.
Yes. A live person answers our phone 24 hours a day, 7 days a week, including holidays. If your gate is stuck open and your property is exposed, or stuck closed with your car trapped inside, call (754) 354-2542 and we’ll dispatch a tech as fast as the schedule allows. We prioritize genuinely urgent calls over routine service work.
Every repair carries our 365-Day Done Right Promise in writing. If the repair fails within 365 days, Calder returns at no charge to make it right. There’s no fine print, no prorated coverage, and no arguing about whether it’s “really” the same problem. If the repair isn’t right, it’s on us. That guarantee is on every job, every time.
Clear the area around the gate motor and control box so the tech can work safely, and have your remote or keypad code ready to test after the repair. If the gate is a community or HOA gate, notify the property manager so we can access the equipment. You don’t need to diagnose anything yourself, just describe the symptoms. That’s all we need to get started.
Schedule Your Electric Gate Repair Service in Fort Lauderdale Today
A gate that won’t open or won’t close doesn’t fix itself, and every day you wait adds stress and usually adds cost. Call (754) 354-2542 now and get a live person, a written price, and a tech who knows exactly what he’s looking at. Your free, no-obligation estimate comes with the 365-Day Done Right Promise in writing before anything is turned on. Call today.
Written by Nico Alvarez, Owner at Calder Gate Repair Fort Lauderdale, serving Broward County since 2009.